Pins move the image for exactly one reason — a bit-banged link on a USART's own
pins has to release that USART — and the matrix said outright that they were no
axis, so the tightest configuration in the space was one nothing built. Not
subtly, either: the 1284's slot ends at flash end, so that build does not merely
exceed the size test's limit, it fails to link. pureboot_{sw,autobaud}_on_usart
{0,1} are gate points in both matrix modes now, and the exhaustive sweep carries
the pins across its whole cross product. The hand-measured table is the gate's
output: 506 B of 512 for the 1284 autobaud on USART0's pins, 504 on USART1's.
pureboot.mute drives the defect itself — an application hands over with USART0
still enabled and the loader on those pins must still answer. Reaching that
needed the runner to know an enabled USART owns its TxD, which simavr does not
model at all: it wires a USART through IRQs and never takes the pin from the
port. It also brings UCSRnB up with TXEN already set where silicon clears the
register, so the runner restores the reset value for the USART it models — the
mute must come from the application, not from power-on. The fixture stays
silent, since nothing is listening on the USART it brings up.
test_handshake.py, written where no gate could run it, is pureboot.handshake.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
R/r/w/F collapse into G and g over a selector byte naming the space — flash,
EEPROM, data, fuse, SPM — with the flash bank in its high nibble. Four command
bodies, four transfer loops and four argument decodes become one of each, and
W joins the same decode instead of keeping an address form of its own. The
loader shrinks while gaining everything below: on the 1284P the stock build
goes 480 -> 432 B and the software one 496 -> 450.
What the freed space buys:
- Data space. On AVR one pointer spans SRAM, the register file and the whole
I/O space, so G over space 2 reads all three. pureboot keeps zero static
RAM and pushes no register, so at loader entry an application's SRAM is
still what the application left there — this is a post-mortem, not just a
poke hole. As its own command it needed a dispatch arm and a loop; as one
more space it is a single ld/st.
- Host-issued SPM. W fills the page buffer and stops; erase, write and RWW
re-enable are writes to space 4, which reach the same fused store-and-SPM
pair through the transfer's own address and data. Any SPM operation, lock
bits included, is now reachable and the loader carries no page-commit logic.
The four-cycle SPMCSR-to-SPM window is why that primitive stays fused: no
host can hit it across a serial link, and that — not the byte count — is
the floor on how low-level a bootloader's primitives can go.
- Byte addresses everywhere. The bank in the selector retires the
word-addressed wire the >64 KiB parts needed, so the 1284s stop being the
outlier.
SERIAL autobaud is a third backend on the same loader, over libavr's
software_autobaud: no clock, no baud, one binary per chip for every F_CPU and
every rate. Activation counts poll iterations rather than seconds and bounds
every wait, so a stray pulse cannot hold an unattended device.
b answers with the version and signature only; the host derives geometry from
the signature, which is what an autobaud build requires anyway. An update image
is a bare slot with no device to ask, so every image carries a six-byte stamp —
the same bytes b answers with, and the source of both — that the loader never
reads from flash and the host refuses to install a mismatch against. The
running-slot write guard moved onto the SPM commit, which covers erase and
write both where guarding W covered neither directly.
The position-independence lint now proves the property instead of a proxy for
it: the image must come out byte-identical linked at a different base.
-fno-move-loop-invariants left the tuned flag set — it was fitted to a command
loop carrying four transfer bodies and costs bytes now that it carries one.
Verified: the exhaustive matrix on all 37 chips (every clock x every baud x
every backend, non-standard rates included, plus the autobaud build) —
8174 size checks, no failures, tightest fit the 1284s' autobaud at 510 of 512.
Behavioral suites green on every chip class: t13a 10/10, t85 11/11, m8 13/13,
m16a 13/13, m48pa 13/13, 328P 23/23, 644A 17/17, 1284P 17/17. Data-space
round trip through --peek/--poke and the autobaud handshake are both red-green
proven.
The two prototype sources and their findings file go; the README carries the
protocol and dev/done.md in libavr carries the reasoning.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Clock, baud, serial backend (hardware USART 0/1 or the software UART on
any pins) and the activation window all resolve through one CMake
function, pureboot_add_loader() in pureboot/CMakeLists.txt — the unit a
downstream project consumes. The default baud is the fastest standard
rate within 2.5 % (the same best-divisor search libavr's solver runs),
gated on software builds by the polled receiver's 100-cycles-a-bit
floor; every explicit pick is re-checked by the compile's static asserts.
The size matrix builds each axis that can move the image — backend x
clock ladder x USART instance, per chip — against the slot budget, and
two nondefault deployments run the whole protocol suite live: the 328P
on its shipped 1 MHz fuses over software serial on TX=PB1/RX=PB5
(pureboot.custom), and the 644A over USART1 (pureboot.usart1). The sim
runner takes -l to bridge any link, paces a fully quiet bridge toward
real time (a free-running 8 M-cycle window loses the reset-race knock),
and the fixture application speaks the deployment it is built for.
The loader itself shed bytes on the way: the return-address high byte
spelled through byteswap (the double swap folds to the one-byte pick),
the info-block address composed instead of bit_cast, and libavr's new
polled-UART helpers replacing the port's uart::detail reaches. Every
combination fits: 458-506 B across the megas' whole matrix, 470-484 B
on the tinies, 556-562 B in the 1284s' 1 KiB slot.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The chip table becomes family blocks covering all 37 targets. The m48s
are a new deployment class: no boot section, so the tiny profile spoken
over the hardware USART — host-patched reset vector, trampoline
hand-over, a 510-byte budget (474 B built), no fuse preflight — while
their RWWSRE store stays the buffer discard (Atmel-8271 §26.2); the
device keys the patch flag and the CPU-halt waits on the curated
boot-section capability and the discard on the RWWSRE bit itself. The
644s' 64 KiB is exactly the 16-bit byte space: plain LPM, byte wire
addresses, 498 B in a 512-byte slot — and their 1 KiB minimum boot
section holds the resident and staging slots together, so self-update
needs no fuse step (the update test's slot pick now keys word-flash on
base >= 64 KiB; base + slot merely touching the boundary stays
byte-addressed). The 1284 joins the 1284P's word-addressed 1 KiB slot at
558 B. BOOT_FUSE gains every boot-sectioned family's ladder and fuse
byte; the planner exercises them all. The sim scaffolding keys
patch-vector-ness instead of the atmega name prefix, the fixture app
picks its clock by family (the tiny25/45/13 builds surfaced the 16 MHz
fallthrough as garbled banners), and the runner's wrapped flash ioctl
performs the m48 discard simavr's no-RWW cores turn into a stray buffer
fill. Sizes across the fleet: 466-504 B megas, 474 B m48s, 498 B 644s,
488-502 B tinies, 558 B 1284s — every chip passing
size/pi/planner/protocol/reloc/update.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Device: boot-section detection probes SPMCR beside SPMCSR, the link
picks any hardware USART through the instance-aware lookups (URSEL
chips included), WDRF reads MCUSR-or-MCUCSR, and the >64 KiB shape
lands — word-addressed wire flash (info flag bit 1, page byte 0 means
256, base as a word address), far reads through flash_load_far, a
single 32-bit byte-cursor page walk (the 256-byte page wraps its low
byte exactly), and slot arithmetic in words (the return address
already is one). Host: addresses stay bytes internally and scale at
the wire, the boot-fuse decode becomes a per-signature table (byte
index + BOOTSZ ladder — the m168A's lives in EXTENDED), and the
planner tests pin every chip's ladder plus the word-addressed info
decode. Tests: the device runner serves every mega over the USART pty,
pbapp banners over the right link, the update rehearsal synthesizes
its assumed fuses from the tool's own table, and the PI lint tracks
the renamed info symbol. All six classic-mega/168A targets pass the
full suite (size, PI, planner, protocol, reloc, self-update) at
466–504 B; the 1284P builds await a libavr far-path slimming to make
its 512.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Cancel the GPIO bridge's cycle timers with the state they drive: avr_reset
drops the TX latch, whose falling edge starts a spurious decode before
bridge_reset runs, and the stale sampler then interleaves with the loader's
first real answer through the shared shift state — the first post-reset
replies came back corrupted and the knock retries burned the activation
window into the application.
Wrap the mega's registered flash ioctl to re-dispatch page erases with Z
masked to the page boundary: simavr's PGERS handler erases spm_pagesize
bytes from Z & ~1 (its PGWRT path masks correctly), wiping the neighbouring
page when Z sits past the page start, which hardware permits (§26.8.1).
Model the write-once temporary buffer in the tiny NVM module — silicon
refuses a second load per word until the buffer clears, and a last-write-
wins model masks real firmware bugs.
Optional arguments select the reset vector (the mega's fuse profiles) and a
raw flash image to resume from (power-fail tests re-enter a dumped state).
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
pureboot.py: reject an empty image file with a clear error instead of
an IndexError deep in the vector-surgery planner; tighten the erase
docstring (order is irrelevant there — every target byte is the same
value, unlike a real flash where page 0 must go last).
pureboot_device.c: the GPIO bridge's bit_cycles used plain truncating
division where the firmware computes its own bit period with
round-to-nearest (uart.hpp: (Clock.hz + Baud.bd/2)/Baud.bd) — one
cycle off per bit on both tinies, harmless in practice but needless
drift against a firmware built to a different constant. Matched
exactly. Also clear the queued-bytes/decode-in-progress bridge state
on the test-only reset signal, so a future reset-mid-transfer scenario
can't feed a freshly reset chip bytes queued for its previous life.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
pureboot.py (Python stdlib only): images as raw binary or Intel HEX,
flash and EEPROM programming with read-back verify, erase composites,
fuse and info readout, activation-timeout configuration, and the
tinies' reset-vector surgery — the trampoline word below the loader,
page 0 written last.
The test spawns a simavr device (pureboot_device.c) — the mega's USART
as a pty; on the tinies a cycle-timed GPIO<->pty bridge for the polled
software UART plus the NVM module simavr's tiny cores lack (their SPM
opcode ioctls into a void and silently does nothing) — and drives it
with the real tool: knock from reset (erased-flash walk on the tinies),
program and verify both memories, timeout write, session reconnect, an
external reset through the patched vector, hand-over, and the fixture
application's banner. Results are cross-checked against ground-truth
memory dumps and an independent decode of the surgery's rjmp words,
red-verified against a sabotaged encoder.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
