pureboot.py: reject an empty image file with a clear error instead of
an IndexError deep in the vector-surgery planner; tighten the erase
docstring (order is irrelevant there — every target byte is the same
value, unlike a real flash where page 0 must go last).
pureboot_device.c: the GPIO bridge's bit_cycles used plain truncating
division where the firmware computes its own bit period with
round-to-nearest (uart.hpp: (Clock.hz + Baud.bd/2)/Baud.bd) — one
cycle off per bit on both tinies, harmless in practice but needless
drift against a firmware built to a different constant. Matched
exactly. Also clear the queued-bytes/decode-in-progress bridge state
on the test-only reset signal, so a future reset-mid-transfer scenario
can't feed a freshly reset chip bytes queued for its previous life.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
pureboot.py (Python stdlib only): images as raw binary or Intel HEX,
flash and EEPROM programming with read-back verify, erase composites,
fuse and info readout, activation-timeout configuration, and the
tinies' reset-vector surgery — the trampoline word below the loader,
page 0 written last.
The test spawns a simavr device (pureboot_device.c) — the mega's USART
as a pty; on the tinies a cycle-timed GPIO<->pty bridge for the polled
software UART plus the NVM module simavr's tiny cores lack (their SPM
opcode ioctls into a void and silently does nothing) — and drives it
with the real tool: knock from reset (erased-flash walk on the tinies),
program and verify both memories, timeout write, session reconnect, an
external reset through the patched vector, hand-over, and the fixture
application's banner. Results are cross-checked against ground-truth
memory dumps and an independent decode of the surgery's rjmp words,
red-verified against a sabotaged encoder.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Each scenario group now runs on its own freshly-reset device: the round-trip
on a blank config page, plus a password-config device that must be sent the
password after the knock to activate, and an emergency-erase device where a
0-byte + two confirms wipes flash, EEPROM and the config page (verified by
reading all three back as 0xff). All three tiers pass every group.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Rewrite the inline-asm tier so it matches the hand-written fixed-baud oracle's
feature set inside the 512 B boot section: watchdog-reset bail, one-wire
half-duplex (RXEN/TXEN toggled per direction, TX turnaround guard),
config-page activation timeout, the password gate (wrong byte hangs draining
the UART), emergency erase (password \0 + double-confirm wipes flash, EEPROM
and the config page), and config/flash/EEPROM read-write. Every geometry,
baud and info-block constant comes from libavr consteval; only the dense
control flow is hand-written. 502 B, byte-identical across generated and
reflect modes.
Test harness: seed the config page from TSB_CONFIG so the password and
emergency-erase paths are exercisable, and clear simavr's AVR_UART_FLAG_POLL_
SLEEP — a host-CPU-saving usleep(1)-per-idle-poll hack that models no hardware
and paces a one-wire loader (which releases TX between bytes) in real time,
distorting protocol timing.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
The native-UART fixed-baud TinySafeBoot protocol, ported onto libavr as a
crt-free boot-section loader, in three variants that trade clarity for size:
tsb_pure 740 B idiomatic C++: SRAM page buffer, separate flash/EEPROM
leaves, shared framing; the polled `unused` guard posture.
tsb_tricks 658 B unified runtime-flag paths (noinline/noclone), call-saved
global-register page walk — attributes only, no asm.
tsb_asm 508 B streaming store + hand-rolled UART/SPM/EEPROM/erase loops;
fits the 512 B boot section (BOOTSZ=11). Trims the optional
password gate and WDT-reset bail — unreachable in C++ with
both (hand-asm is ~15 % denser). Tiers 1-2 keep them and
live in the 1 KB section they fit.
All three are .text byte-identical across libavr's generated and reflect modes.
The CMake build strips the leaked -O3 (a Release build is silently -O3, not the
-Os this loader is measured against) and gates each variant's size against its
section. A simavr harness (test/device.c + test/tsbtest.py) drives the real wire
protocol over a pty and flashes the device; the size and protocol tests run in
ctest. Verified byte-for-byte against the reference tsbloader_adv (C#/mono):
activate, read info, flash write + verify.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
