The temporary page buffer is write-once per word, so a page filled over
one an earlier writer left dirty programs the stale words. The same
datasheet clause carries the cure: the buffer auto-erases after a page
write (§26.2.1; §19.2 on the tinies), so the corruption clears itself by
happening, and rewriting the page programs correctly.
The loader therefore clears the buffer nowhere. The tinies' CTPB and the
m48s' RWWSRE discard are gone; the boot-sectioned megas keep only the
trailing RWWSRE they need anyway to re-enable the RWW section for
read-back, which discards the buffer as a side effect and keeps them off
the path entirely. 434 B on the tiny13s, 438-442 on the tiny25/45/85,
430 on the m48s; the megas are unchanged, the 1284s still 506.
The host takes over the guarantee: a flash page that reads back wrong is
rewritten up to RETRIES times before the run stops. Both read-back paths
repair — verify_pages for programming, and write_differing, which is the
loader-update path where a page left wrong is a half-written loader slot.
That one is not hypothetical: deleting the discard made attiny85
pureboot.rehome fail deterministically there, the only flow still
assuming the old contract.
Protocol-visible, so README's W command says it: one W may program the
wrong bytes after a refused page, or after an application that
self-programmed entered without a reset, and a host that programs without
reading back cannot trust it.
Tests: pureboot.dirty drives the case the loader declines to guard — the
fixture application dirties every buffer word and jumps in with no reset
(hardware forbids that on a boot-sectioned mega, but simavr dispatches SPM
from anywhere, which is what makes it constructible) — and asserts a bare
verify sees the corruption, the repairing verify fixes it in one rewrite,
and it stays fixed. pbreloc asserts the same shape after a refusal.
test_planner covers the bound against a fake device: one bad write
repaired in a single rewrite, a page that never comes good stopping after
exactly three.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Clock, baud, serial backend (hardware USART 0/1 or the software UART on
any pins) and the activation window all resolve through one CMake
function, pureboot_add_loader() in pureboot/CMakeLists.txt — the unit a
downstream project consumes. The default baud is the fastest standard
rate within 2.5 % (the same best-divisor search libavr's solver runs),
gated on software builds by the polled receiver's 100-cycles-a-bit
floor; every explicit pick is re-checked by the compile's static asserts.
The size matrix builds each axis that can move the image — backend x
clock ladder x USART instance, per chip — against the slot budget, and
two nondefault deployments run the whole protocol suite live: the 328P
on its shipped 1 MHz fuses over software serial on TX=PB1/RX=PB5
(pureboot.custom), and the 644A over USART1 (pureboot.usart1). The sim
runner takes -l to bridge any link, paces a fully quiet bridge toward
real time (a free-running 8 M-cycle window loses the reset-race knock),
and the fixture application speaks the deployment it is built for.
The loader itself shed bytes on the way: the return-address high byte
spelled through byteswap (the double swap folds to the one-byte pick),
the info-block address composed instead of bit_cast, and libavr's new
polled-UART helpers replacing the port's uart::detail reaches. Every
combination fits: 458-506 B across the megas' whole matrix, 470-484 B
on the tinies, 556-562 B in the 1284s' 1 KiB slot.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The chip table becomes family blocks covering all 37 targets. The m48s
are a new deployment class: no boot section, so the tiny profile spoken
over the hardware USART — host-patched reset vector, trampoline
hand-over, a 510-byte budget (474 B built), no fuse preflight — while
their RWWSRE store stays the buffer discard (Atmel-8271 §26.2); the
device keys the patch flag and the CPU-halt waits on the curated
boot-section capability and the discard on the RWWSRE bit itself. The
644s' 64 KiB is exactly the 16-bit byte space: plain LPM, byte wire
addresses, 498 B in a 512-byte slot — and their 1 KiB minimum boot
section holds the resident and staging slots together, so self-update
needs no fuse step (the update test's slot pick now keys word-flash on
base >= 64 KiB; base + slot merely touching the boundary stays
byte-addressed). The 1284 joins the 1284P's word-addressed 1 KiB slot at
558 B. BOOT_FUSE gains every boot-sectioned family's ladder and fuse
byte; the planner exercises them all. The sim scaffolding keys
patch-vector-ness instead of the atmega name prefix, the fixture app
picks its clock by family (the tiny25/45/13 builds surfaced the 16 MHz
fallthrough as garbled banners), and the runner's wrapped flash ioctl
performs the m48 discard simavr's no-RWW cores turn into a stray buffer
fill. Sizes across the fleet: 466-504 B megas, 474 B m48s, 498 B 644s,
488-502 B tinies, 558 B 1284s — every chip passing
size/pi/planner/protocol/reloc/update.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The far machinery (ELPM reads, RAMPZ page commands, wire-word math)
costs ~46 B over the m328P's 504, and the tsb-calibrated C++-to-asm
gap says no implementation of this feature set reaches 512 on this
chip — a boundary its hardware does not have anyway: the 1284P's
smallest boot sector is 1 KiB. The slot therefore becomes
per-geometry (512 B, or 1 KiB past 64 KiB), which the host derives
from the word-addressing flag; slot arithmetic unifies (the index is
the wire high byte with its low bit dropped in either unit), the
update preflight demands a two-slot boot section in the chip's own
terms, and pbapp's hand-back jumps to the real slot base. libavr's
far primitives split their RAMPZ/Z asm operands (a page never
crosses 64 KiB, so callers keep a byte and a 16-bit cursor — the
32-bit address folds away; flash_load_far's byte form becomes the
out-RAMPZ+elpm pair avr-libc's pgm_read_byte_far rebuilds per call),
and the host splits reads at 64 KiB boundaries. All ten chips pass
the full suite — the 1284P at 558 B including protocol, relocation,
and the power-fail self-update — with pureboot byte-identical across
generated and reflect modes everywhere, and the original three
chips' images unchanged to the byte (488/502/504).
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Device: boot-section detection probes SPMCR beside SPMCSR, the link
picks any hardware USART through the instance-aware lookups (URSEL
chips included), WDRF reads MCUSR-or-MCUCSR, and the >64 KiB shape
lands — word-addressed wire flash (info flag bit 1, page byte 0 means
256, base as a word address), far reads through flash_load_far, a
single 32-bit byte-cursor page walk (the 256-byte page wraps its low
byte exactly), and slot arithmetic in words (the return address
already is one). Host: addresses stay bytes internally and scale at
the wire, the boot-fuse decode becomes a per-signature table (byte
index + BOOTSZ ladder — the m168A's lives in EXTENDED), and the
planner tests pin every chip's ladder plus the word-addressed info
decode. Tests: the device runner serves every mega over the USART pty,
pbapp banners over the right link, the update rehearsal synthesizes
its assumed fuses from the tool's own table, and the PI lint tracks
the renamed info symbol. All six classic-mega/168A targets pass the
full suite (size, PI, planner, protocol, reloc, self-update) at
466–504 B; the 1284P builds await a libavr far-path slimming to make
its 512.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
libavr now exposes avr::hw::db.signature (compile-time, from the ATDF), so the
info block drops its per-chip hardcoded signature() for the db constant. The
loaders are byte-identical across modes with the correct signature, sizes
unchanged (488/502/504).
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The image now runs from any 512-byte slot with every command intact:
control flow stays PC-relative, the write guard keys on the running slot
(the return-address anchor, computed once), the info block is addressed
from that same anchor as a byte pair (no absolute 16-bit address in the
image), and the application jump is an indirect call through a noipa-
laundered pointer to the absolute entry. 'J' — jump to a wire word
address, the one transfer primitive — replaces 'G': the host knows the
application entry from the info block, and moving between loader copies
needs arbitrary targets. The activation window is a compile-time 8 s
(PUREBOOT_TIMEOUT overrides), counted as a single calibrated poll loop.
A refused page no longer poisons the write-once temporary buffer (a real
silicon trap: the next write would program the drained data): every page
write discards the buffer first — CTPB on the tinies, on the mega the same
RWWSRE store that re-enables RWW after programming. The tinies' post-op
busy-waits go with it: their CPU halts through page erase and write.
488 / 502 / 504 B on t13a / t85 / mega — under the tinies' 510-byte budget,
whose last slot word is the host-managed trampoline: the resident's holds
the application entry, a staging copy's the jump through which an abandoned
update still times out into a loader.
The host tool updates the loader with itself: --update-loader installs the
identical image one slot below the resident, jumps into it, lets it rewrite
the resident, and restores the staging region from a state file — each
phase idempotent off the flash state, resumable after any interruption
(t13a: the staging slot carries the reset vector, written last in and
first out; t85: word 0 redirected around the resident rewrite; mega:
fuse-matrix preflight with a hard BOOTSZ gate and --assume-fuses for
simulators). Application flashing recovers by reset from any interruption:
patched page 0 and trampoline first, erase descending, and a walk-region
refusal behind --force on BOOTRST-below-loader megas.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
No inline assembly, no global register variables; libavr does the
datasheet work. The device speaks primitives — flash read/page-program,
EEPROM read/write, fuse read, info block, EEPROM-resident activation
timeout, hand-over — and verify, erase, reset-vector surgery, and
timeout configuration live in the host tool. 490 B on the ATtiny13A,
510 B on the ATtiny85, 484 B on the ATmega328P, each linked into the
top 512 bytes of flash; per-chip size tests gate all three.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
