The reading pass over this repo found the tiers disagreeing with themselves,
and every fix here was measured.
**The turn-around guard is real code.** `tsb_asm` and `tsb_tricks` wrote
`for (std::uint8_t guard = 46; guard; --guard) ;` between taking the one-wire
line and the first UDR0 store, under a comment naming it a turn-around guard.
It has no side effect, so GCC deleted it - `sts UCSR0B` went straight to
`sts UDR0` - while the hand-written oracle spends six bytes on that wait and
libavr's own half-duplex spends them through `delay::cycles`. Two of four
tiers described a feature they did not have, which made the size gradient a
comparison between different loaders. `avr::delay::cycles<one bit time>()`
bottoms out in asm and cannot be deleted.
**The entry belongs to the library, and hand-rolling it was expensive.** Three
tiers wrote their own naked `.vectors` stub with `asm volatile("clr
__zero_reg__")` - which design.md fences to libavr and never a port, and which
`tsb_tricks` denied having in its own title line. `avr::startup::entry` also
keeps the body `noinline` for a stated reason: avr-ld must not shrink a
`.vectors` section, so a loader inlined into one forfeits call relaxation
everywhere. `tsb_pure` came out **836 -> 734** bytes for that alone.
`stack::hardware` - the reset value this part guarantees, with the write kept
where a part does not - saved another four, which is what let `tsb_asm` afford
the guard it had been four bytes short of. It fills its 512-byte section
exactly now, with the whole feature set.
**`tsb_pure` had no receive timeout.** Its `rx()` was `read_blocking()`, so a
silent host wedged the password gate and the command loop forever - the one
fix the oracle's own header lists by name, and one the other three tiers
implement. It is bounded now, and 0-on-silence falls through every compare as
theirs does.
Three gates could pass without proving anything. `sizes.py check-readme`
reported a match when every row's lookup missed; `check_size.cmake` used
`CMAKE_MATCH_1` without checking the match succeeded, which is the guard its
sibling `check_unit.cmake` has and it is the size gate; `check_pi.py` raised
IndexError instead of reporting a position-independence break that changed the
image's length. And `check.sh` spelled the 37-chip list a second time beside
make_presets.py, where a chip added to one and missed in the other is a
silently unbuilt chip - it reads the presets now, and produces the same 37 and
12.
tsbtest.py gains the scenario nothing covered: a wrong password byte must
neither activate the loader nor reach the emergency erase behind it. Red-green
on a tier with the refusal removed.
Smaller, all measured or checked: the signature is `hw::db.signature` in every
tier as the page size and EEPROM end beside it already were; `act_min` derives
from the clock; pureboot.py's `rjmp` helpers refuse a part past rjmp's
4096-word reach rather than silently folding an offset (unreachable today, the
ATtiny85 sits exactly on it); the host tool calls space 2 `data` as the wire
and the loader do; `.clangd` strips the fifth GCC-only flag the build passes;
pbrig's bitclock guard reads its own ladder; pbreloc's unexplained retry is
gone, the write being reliable on five runs without it; and the four tier
sizes live in oracle/README.md's table instead of four file headers and a
CMake comment.
`--poke` before `--peek` turned out to be right - pbtest.py round-trips a poke
through the peek behind it - so the parser order and README say so now.
Every chip green, the README size table matching every image.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
The pin crosses libavr's phase 6 - the renamed system surface, the named
serial configs, the receiver-tolerance table, the paged SPM receipts -
and every loader image comes out size-identical: the full matrix on six
representative chips (the exhaustive cross product on three of them),
the stock and autobaud columns untouched, the four tsb tiers back on
their recorded floors at 510/526/638/836.
Byte parity was not free, and the two libavr defects it surfaced were
fixed there rather than absorbed here. The EEPROM write procedure's
step 2 - the SPMEN spin - had landed unconditionally and cost every
build six bytes for a wait a polled loader can never take; it is scoped
now, and the loaders state the datasheet's own omission clause
(spm_interlock::omitted, DS40002061B 8.6.3). The blocking page
erase/write grew an internal wait the tiers' settle() already provides,
so the tiers issue the command form and pureboot keeps its host-driven
sp_spm path.
What the port states rather than inherits: the stock 115200 at 16 MHz
sits +2.1 % past the receiver-tolerance table libavr now holds rates
to, so the hardware links say .allow_baud_error = true - the same
2.5 % envelope pureboot_baud_feasible() has always enforced, proven on
silicon across the fleet. rx_ready() reads readable() now.
Alongside the pin: rule 33's ASCII sweep over every source (docs keep
their typography), rule 34's InsertBraces in .clang-format with the
tree reformatted, std::array over the simavr runners' raw buffers, and
the stale Studio size in ide/README.md replaced by the claim its
check-flags gate actually holds.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
The flag was plumbed through pbrig.Deployment to the host-tool subprocess
calls and nowhere else, so identity() and scan() opened a raw port and drove
a shared line as though it were two wires. On real one-wire hardware the
adapter's echo answers the knock before the device does, so the suite would
have died at its very first check — "the loader never answered; nothing below
can be trusted" — for the one deployment the flag exists to test, and every
result after it is gated on that check passing.
Both now open through pbrig.Rig.open_port(), which applies the deployment's
link mode. The gap underneath was that only the subprocess path could reach
those facts at all; anything driving the protocol in-process had to restate
them, and did not.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
HALF_DUPLEX deploys a shared line per backend. The hardware USART takes
the library's .half_duplex turn-around — RXD and TXD tied off-chip, each
reply byte held to transmit-complete before the line can be released
(m8 404 B, m328P 440, 1284P 460; the window poll runs through the
outlined release-line call at 18 or 22 cycles a poll, measured off the
built loops and held per chip by pureboot.window.halfduplex). The
software and autobaud links fold onto the RX pin — RX == TX spells the
same — and cost nothing: the frame's direction wrap is what the dropped
second-pin init paid, and the worst image in the space is unchanged at
the 1284s' 502 of 512, now with its one-wire twin proven equal across
the exhaustive matrix. The host gains --one-wire, the echo discard a
shared line requires: the adapter's echo is matched byte for byte and a
reply interleaving a blind write — a loader already in session
re-prompts inside the knock — is held for the reader. The device runner
models the shared line by direction (drives only while the firmware's
DDR reads input, decodes only while the firmware owns it, supplies the
host-side echo), extends the USART pin-ownership model to RXEN's hold
on RXD, and starts the pty USART from the datasheet's zeroed UCSR#B:
simavr's TXEN-set reset plus its clear-UDRE-on-TXEN-drop otherwise
wedges the first transmitter after a receiver-only program, which the
half-duplex window gate caught as a banner that never came. v7 is
tagged at its era's last commit; v8 changes nothing on the wire.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
check.sh proves the protocol under simavr on every chip; it cannot prove a
board. Two things live only on silicon — an RC oscillator that is not on its
nominal, and a reset edge that has to come from somewhere — and until now the
scripts that reached them were per-session scratch on the machine holding the
programmer, which is where the ATtiny13A run's findings nearly stayed.
pbrig.py is the primitives, knowing nothing per-board: every deployment fact is
a flag or a PUREBOOT_* variable. Two rig facts are encoded in it because neither
is guessable and each cost a session to learn: an ISP access *is* the reset edge
where the adapter's DTR is unwired, so a session begins with an ISP touch and
knocks immediately after; and avrdude splits -U on colons, so a Windows drive
letter breaks the spec and every file goes as a bare name with avrdude run in
its own directory. Its `rate` subcommand is the one that turns "the loader is
silent, so the wiring must be wrong" into a number, by sweeping the host rate
against a fixed cycles-per-bit transmitter — PUREBOOT_HEARTBEAT makes the
existing fixture into one, software link only, since the hardware-link idle owes
the self-update tests its command loop.
pbhw.py takes every bound from the info block the loader reports, so one run
covers a 1 KiB tiny and a 128 KiB mega alike. Both are exercised on an ATtiny13A:
backup verified against a known-good capture, the clock measured at 9.048 MHz
against a 9.6 MHz nominal, and the suite 11/11.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
