The pin crosses libavr's phase 6 - the renamed system surface, the named
serial configs, the receiver-tolerance table, the paged SPM receipts -
and every loader image comes out size-identical: the full matrix on six
representative chips (the exhaustive cross product on three of them),
the stock and autobaud columns untouched, the four tsb tiers back on
their recorded floors at 510/526/638/836.
Byte parity was not free, and the two libavr defects it surfaced were
fixed there rather than absorbed here. The EEPROM write procedure's
step 2 - the SPMEN spin - had landed unconditionally and cost every
build six bytes for a wait a polled loader can never take; it is scoped
now, and the loaders state the datasheet's own omission clause
(spm_interlock::omitted, DS40002061B 8.6.3). The blocking page
erase/write grew an internal wait the tiers' settle() already provides,
so the tiers issue the command form and pureboot keeps its host-driven
sp_spm path.
What the port states rather than inherits: the stock 115200 at 16 MHz
sits +2.1 % past the receiver-tolerance table libavr now holds rates
to, so the hardware links say .allow_baud_error = true - the same
2.5 % envelope pureboot_baud_feasible() has always enforced, proven on
silicon across the fleet. rx_ready() reads readable() now.
Alongside the pin: rule 33's ASCII sweep over every source (docs keep
their typography), rule 34's InsertBraces in .clang-format with the
tree reformatted, std::array over the simavr runners' raw buffers, and
the stale Studio size in ide/README.md replaced by the claim its
check-flags gate actually holds.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
--update-loader works by entering copies of the *new* image and letting them
rewrite the resident. Those copies speak the link they were built for, but the
host went on knocking with the session's baud and backend — the resident's. Where
the image changed either, the staging copy was installed and then never answered:
resident untouched, and on a 1 KiB tiny the staging slot is the whole application
region, so the application was already gone.
The wire cannot be probed for it. 512 bytes of position-independent code carry no
header saying what rate they were built for, so the operator declares it:
--staged-baud and --staged-autobaud, applied from the jump into the staging copy
onward. Retuning goes through the open port — SetCommState or tcsetattr on the
live handle, never a reopen — because a DTR pulse would reset the copy being
talked to. Undeclared against a changed link it still cannot work, but the error
now names that as the cause instead of reporting the bare activation timeout that
sent the operator looking at wiring.
The README's idempotence claim needed the same qualification: from step 2 a
re-run must reach the new image, and after step 3 word 0 points at the staging
copy, so on a patched-vector part the resident's link reaches nothing at all.
Found on an ATtiny13A, where two controls differing only in the activation window
updated cleanly and so isolated the link as the variable.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
