BlackMark
837b832bc7
The pin crosses libavr's phase-6 close and the guideline sweep behind it; the image is byte-identical in both modes at 8206 bytes. The port's own sweep, against the same rules. Every mutable `static inline` takes `m_` - uptime's counter, the sampler's window, the controller's five, the statistics histogram and the terminal's line state (rule 46; a private `static constexpr` is a constant rather than state and keeps its bare name). The command table is `std::to_array` and the serial config breaks one member per line (rules 36, 40). And three numbers get the name they already had somewhere: duty goes through `percent_t::of()` rather than a hand-built basis-point count, the ADC's top count is `thermistor::adc_full_scale` instead of 1023 in four places, and the two `0xffffffff` are `open_circuit` - which was already declared five lines away - and `never_written`, which replaces a comment explaining the literal (rules 5, 6, 41). Measured, not assumed: rendering `adc_full_scale` into the `show` line instead of leaving it in the message string cost 6 bytes, so the display text stays text. Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
13 lines
605 B
CMake
13 lines
605 B
CMake
# The board has no reset line and no programming header, so the loader-entry
|
|
# route in the emitted image is the only thing standing between a firmware change
|
|
# and an unreflashable board.
|
|
find_package(Python3 COMPONENTS Interpreter)
|
|
if(Python3_FOUND)
|
|
add_test(NAME fantemp.reachability
|
|
COMMAND ${Python3_EXECUTABLE} ${CMAKE_CURRENT_SOURCE_DIR}/check_reachability.py
|
|
--objdump ${CMAKE_OBJDUMP} --elf $<TARGET_FILE:fantemp>
|
|
--image $<TARGET_FILE_DIR:fantemp>/fantemp.bin)
|
|
else()
|
|
message(STATUS "Python not found - the reachability check is skipped")
|
|
endif()
|