The renames land (interrupt_guard, consume_reset_cause, set_duty), the
sampler binds its input in the new converter shape (the input pack plus
in<>::start() as free-running's one kick), and the console states
.allow_baud_error = true for the 115200-at-16-MHz this board has always
spoken - the receiver-tolerance table libavr now enforces is stricter
than the rate's own +2.1 %. The loader probe reads through
avr::flash_load instead of raw pgmspace, the terminal's line buffer is
std::array with backspace and delete named, the tree is reformatted
under InsertBraces, and the sources are ASCII.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Six things the port had dropped or got wrong, and the one that matters is
the last.
The help is a table again — name, dots, description, one command per line
— instead of a single line of bare words that said nothing about what any
of them did. The layout is the original's, colons at column 12, which
`bootloader` at ten characters is what sets.
Abbreviations are back, and they were a feature: any prefix resolves to
the first command it matches, so `up` is uptime and `st` is statistics.
Order does the disambiguating, which is why the table is in the
original's dispatch order and new entries go on the end — appending
cannot take an abbreviation that already meant something. `reset` keeps
the original's exception and must be typed in full: `r` should not be
able to clear the histogram.
The histogram gets its resolution back. The bar was capped at 40 columns
where the original scaled to 100, and on a distribution this narrow that
threw away most of the difference between neighbouring buckets. Same
normalisation as before: divide by whatever makes the tallest bucket fit.
The sample count moves to a fixed ten-column field before the bar, so the
numbers read as a table instead of trailing off the ragged right end.
`version` exists again, and this is 2.1 — 2.0 being the port as it stood.
Added while here: `save`, to force the writeback that otherwise waits up to
thirty minutes; the resistance in `show`, which is the one number that
says *why* a temperature is wrong and which the original printed; a
report when a line overflows the buffer rather than silently acting on
its head; "no data yet" where there is none; and a blank line after each
command's output.
And the way out. `bootloader` now jumps rather than resetting, because
pureboot hands straight back on WDRF by design — so the legacy
watchdog-reset hand-over reaches it and opens no window, which on a board
with no reset line is a board that cannot be reflashed. Two more bugs in
the same three lines: the target was 0x7800, a 2 KB boot section's base,
which on this board's 512-byte section reads erased and made the check
false and the command a no-op; and UCSR0B was left set, which mutes a
loader that bit-bangs the pin the USART still owns. All three are now
read back out of the emitted image by ctest, the address and the watchdog
red-proven against exactly the legacy behaviour they exist to catch.
libavr advances to 71cfb2f. Verified on the board: FanTemp v2.1, min 0 C
/ max 74 C matching what 1.8b reported off the same EEPROM, the fan curve
within one percentage point of the legacy double-precision one at every
5 C from 15 to 60, and `bootloader` -> pureboot 7 -> back to a running
application.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
