build: the libavr pin advances past phase 6, at byte parity everywhere

The pin crosses libavr's phase 6 - the renamed system surface, the named
serial configs, the receiver-tolerance table, the paged SPM receipts -
and every loader image comes out size-identical: the full matrix on six
representative chips (the exhaustive cross product on three of them),
the stock and autobaud columns untouched, the four tsb tiers back on
their recorded floors at 510/526/638/836.

Byte parity was not free, and the two libavr defects it surfaced were
fixed there rather than absorbed here. The EEPROM write procedure's
step 2 - the SPMEN spin - had landed unconditionally and cost every
build six bytes for a wait a polled loader can never take; it is scoped
now, and the loaders state the datasheet's own omission clause
(spm_interlock::omitted, DS40002061B 8.6.3). The blocking page
erase/write grew an internal wait the tiers' settle() already provides,
so the tiers issue the command form and pureboot keeps its host-driven
sp_spm path.

What the port states rather than inherits: the stock 115200 at 16 MHz
sits +2.1 % past the receiver-tolerance table libavr now holds rates
to, so the hardware links say .allow_baud_error = true - the same
2.5 % envelope pureboot_baud_feasible() has always enforced, proven on
silicon across the fleet. rx_ready() reads readable() now.

Alongside the pin: rule 33's ASCII sweep over every source (docs keep
their typography), rule 34's InsertBraces in .clang-format with the
tree reformatted, std::array over the simavr runners' raw buffers, and
the stale Studio size in ide/README.md replaced by the claim its
check-flags gate actually holds.

Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>

test/pbreloc.py

@@ -2,7 +2,7 @@
 """Position-independence acceptance test: the identical binary, flashed one
 slot below the resident, must serve the complete command set from there. The
 info block must come back byte-identical, and the staged copy must be able to
-rewrite the resident verbatim — which is the whole of what relocation is for.
+rewrite the resident verbatim - which is the whole of what relocation is for.
 
 Usage: pbreloc.py <device_bin> <pureboot_elf> <mcu> <hz> <base_hex> <page>
                   <baud> <tool_py> <workdir>
@@ -63,7 +63,7 @@ def main():
         if loader.read_eeprom(0, len(pattern)) != pattern:
             fail("EEPROM round-trip through the staged copy")
 
-        # The resident slot, written from the copy standing beside it — the
+        # The resident slot, written from the copy standing beside it - the
         # whole point of relocating. pureboot 9 dropped the running-slot guard
         # that used to sit behind this, so the probe that used to accompany it
         # (aim a write at the copy's *own* slot and watch it be refused) is