pureboot 5: one command pair for every memory, and a clock-free backend

R/r/w/F collapse into G and g over a selector byte naming the space — flash,
EEPROM, data, fuse, SPM — with the flash bank in its high nibble. Four command
bodies, four transfer loops and four argument decodes become one of each, and
W joins the same decode instead of keeping an address form of its own. The
loader shrinks while gaining everything below: on the 1284P the stock build
goes 480 -> 432 B and the software one 496 -> 450.

What the freed space buys:

  - Data space. On AVR one pointer spans SRAM, the register file and the whole
    I/O space, so G over space 2 reads all three. pureboot keeps zero static
    RAM and pushes no register, so at loader entry an application's SRAM is
    still what the application left there — this is a post-mortem, not just a
    poke hole. As its own command it needed a dispatch arm and a loop; as one
    more space it is a single ld/st.
  - Host-issued SPM. W fills the page buffer and stops; erase, write and RWW
    re-enable are writes to space 4, which reach the same fused store-and-SPM
    pair through the transfer's own address and data. Any SPM operation, lock
    bits included, is now reachable and the loader carries no page-commit logic.
    The four-cycle SPMCSR-to-SPM window is why that primitive stays fused: no
    host can hit it across a serial link, and that — not the byte count — is
    the floor on how low-level a bootloader's primitives can go.
  - Byte addresses everywhere. The bank in the selector retires the
    word-addressed wire the >64 KiB parts needed, so the 1284s stop being the
    outlier.

SERIAL autobaud is a third backend on the same loader, over libavr's
software_autobaud: no clock, no baud, one binary per chip for every F_CPU and
every rate. Activation counts poll iterations rather than seconds and bounds
every wait, so a stray pulse cannot hold an unattended device.

b answers with the version and signature only; the host derives geometry from
the signature, which is what an autobaud build requires anyway. An update image
is a bare slot with no device to ask, so every image carries a six-byte stamp —
the same bytes b answers with, and the source of both — that the loader never
reads from flash and the host refuses to install a mismatch against. The
running-slot write guard moved onto the SPM commit, which covers erase and
write both where guarding W covered neither directly.

The position-independence lint now proves the property instead of a proxy for
it: the image must come out byte-identical linked at a different base.
-fno-move-loop-invariants left the tuned flag set — it was fitted to a command
loop carrying four transfer bodies and costs bytes now that it carries one.

Verified: the exhaustive matrix on all 37 chips (every clock x every baud x
every backend, non-standard rates included, plus the autobaud build) —
8174 size checks, no failures, tightest fit the 1284s' autobaud at 510 of 512.
Behavioral suites green on every chip class: t13a 10/10, t85 11/11, m8 13/13,
m16a 13/13, m48pa 13/13, 328P 23/23, 644A 17/17, 1284P 17/17. Data-space
round trip through --peek/--poke and the autobaud handshake are both red-green
proven.

The two prototype sources and their findings file go; the README carries the
protocol and dev/done.md in libavr carries the reasoning.

Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>

test/pureboot_device.c

@@ -182,9 +182,16 @@ static avr_cycle_count_t tx_sample(avr_t *mcu, avr_cycle_count_t when, void *par
 {
 	(void)mcu;
 	(void)param;
-	tx_shift = (uint8_t)((tx_shift >> 1) | (tx_level ? 0x80 : 0));
-	if (++tx_bit < 8)
+	if (tx_bit < 8) {
+		tx_shift = (uint8_t)((tx_shift >> 1) | (tx_level ? 0x80 : 0));
+		if (++tx_bit < 8)
+			return when + bit_cycles;
+		/* The byte is not delivered until its stop bit has passed. A real
+		 * receiver cannot answer sooner, and a host that did would put its
+		 * start bit on the wire while the device is still driving the stop
+		 * bit — which the device, transmitting, is not watching for. */
 		return when + bit_cycles;
+	}
 	if (write(pty_master, &tx_shift, 1) != 1)
 		fprintf(stderr, "device: pty write lost a byte\n");
 	tx_active = 0;